

The TTS dip slide measures a total count (CLED) on one side and coliforms count (MacConkey3) on the other. For urine screening tests.
By buying this product you can collect up to 55 points
Volume discounts
Quantity | Price | You Save |
---|---|---|
51 | £11.33 | Up to £32.14 |
101 | £10.89 | Up to £107.75 |
251 | £10.26 | Up to £427.48 |
501 | £9.70 | Up to £1,131.88 |
1000 | £7.94 | Up to £4,024.54 |
The TTS dip slide is a dual media slide for clinical applications. This standard urine dipslide measures a total count and detects coliforms.
It comes in a pack size of 10 slides per box (minimum order of 5 boxes). The slide has a flexible paddle and is located in a shatterproof container.
Flexible Paddle
Each dipslide features a virtually unbreakable and flexible paddle allowing for even, full surface testing.
Easy Run Off Design
Due to the design of the dipslide, fluids will drain off quickly during testing.
Recessed Handle
Each slide has a handle built into the lid that is recessed to help keep your fingers dry during testing.
Side Indicator
One side of the slide will have a circle indicator so you know which side was used for testing which type of contaminant.
Dual Sided
Each dipslide is dual sided to allow multiple contamination testing with one test.
Thick Reliable Agar
Each agar is thick (approx 4mm) and raised above the dipslide to allow for easy surface testing.
CLED agar - This agar is used for urine diagnostics and supports the growth of urinary potential pathogens. A viable count of urinary organisms is detected using this agar.
MacConkey3 - For the detection of coliforms. In this case, the agar is used in clinical applications.
In Liquids
Simply remove the dipslide and immerse in the sample for approx 10 seconds. Remove dipslide and allow to drain for a few seconds, then replace the slide back into the tube and incubate for a minimum of 24 hours (up to a maximum of 48 hours).
Surface testing
Remove the Dipslide from the container and press against the surface for approx 10 seconds. Replace the slide back into the tub and incubate for a minimum of 24 hours (up to a maximum of 48 hours).
A comparison chart is included so you can easily compare your results.
Step 1 : Remove slide
Carefully remove the sterile CLED / MacConkey 3 dip slide from its tube ensuring that no contact is made with the agar (to avoid contamination).
Step 2 : If Surface Testing
For surface testing, press the CLED / MacConkey 3 dipslide onto the surface. If needed, place a finger on the bottom of the slide (on the plastic, not the agar) to apply extra pressure.
Step 2 : If liquid testing
For liquid testing, immerse the CLED / MacConkey 3 dipslide into the fluid for 10 seconds then remove and allow to drain for a few seconds.
Step 2 : If swab testing
Apply a sample of the test substance to a sterile swab and gently apply to the agars.
Step 3 : Incubate Slide
Label the tube with the included stickers then place the slide into an incubator and allow to incubate.
Step 4 : Compare results
Count the amount of colonies that have grown on the slide and compare them to the comparison chart provided.
Specific References
£11.96
The BV dipslide provides enterobacteriaceae count on the front red/purple side and Staphylococci count on yellow rear...
View£152.13
The Bacteria dip slide test kit contains 1 GNAT MX2 Dipslide Incubator and 20 BTM2 Dipslides (ideal for testing for...
View